I am using 3660 and 3640 router for doing Video over IP. I don't have problem in doing same but I am facing problem in monitoring of the same. I have applied policy map and when I am giving command " Sh policy-map " on 3640 it gives me more details while on 3660 it commands doesn't give me details.Also for the sh access-list I am not getting any output on 3660 router.While I am using same IOS version on both router then why it is happening ? Also on 1720 with same IOS I am facing problem. Can suggest me what IOS upgrade will solve this issue ?
Sh tech for 3640 router
------------------ show version ------------------
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3640-I-M), Version 12.1(5)T8, RELEASE SOFTWARE (fc1)
From your show tech output I see that the 3640 and 3660 are running different IOS versions. There could be some problem with the image that you are running with the 3660. Just check out with the same version image as that of 3640.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.