Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

QoS over GRE tunnel

Hi,

we have two remote sites connected to each other using a GRE tunnel. I wanted to apply a QoS policy to ensure two video cameras can have at least 400kbps bandwidth available. When I apply this QoS policy to the Tunnel interface I am getting error message saying CBWFQ is not supported.

policy-map polycom-pm

class polycom-cm

bandwidth 400

class class-default

(config-if)#service-policy output polycom-pm

Class Based Weighted Fair Queueing not supported on interface Tunnel12

does anyone know of any tricks to get around this problem and be able to reserve/guarantee bandwidth across a GRE tunnel?

Thank you!

1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

Re: QoS over GRE tunnel

Hi

If I remember correctly you need to apply the QoS policy to the physical interface, and then use the qos pre-classify command on the tunnel interface...

This copies packet markings into the extra tunnel header (which is all that intermediate devices will see).

See this link:

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1835/products_command_reference_chapter09186a0080087f3c.html#wp1072696

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
2 REPLIES
Super Bronze

Re: QoS over GRE tunnel

Hi

If I remember correctly you need to apply the QoS policy to the physical interface, and then use the qos pre-classify command on the tunnel interface...

This copies packet markings into the extra tunnel header (which is all that intermediate devices will see).

See this link:

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1835/products_command_reference_chapter09186a0080087f3c.html#wp1072696

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: QoS over GRE tunnel

Aaron,

thanks for the guidelines. I had to look through http://www.cisco.com/application/pdf/en/us/guest/netsol/ns241/c649/ccmigration_09186a00801ea79c.pdf to figure out the exact configuration for QoS over GRE over IPSEC ; the trick is to apply "qos pre-classify" to both tunnel and crypto map.

thanks again.

John.

562
Views
5
Helpful
2
Replies