I have a customer that is wanting to have the ability to do caller ID blocking on a per call basis. Is this possible in CM 3.3? I have tried contacting the LEC and they cannot do this on a PRI so it will have to be controlled on our side. I have confirmed that I can block or unblock the CID completely but am not sure how to do it on a per call basis.
Anyone have any thoughts on this? From what I can tell, I just need to setup a route pattern that does not send the caller ID info. Is that correct? What about the router - it has the SRST capability. Is there anything I need to change on that?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...