1)I am configuring the Route Pattern for my Remote Site
2)I have HO where CCM is located and remote site where via MPLS link i am trying to register my phones,phones are registered CUG calling is happening between HO and Remote site but not able to make LOCAL,STD,ISD calls from Remote site
3)My Remote site numb is 4502XXX and i have configured router pattern for STD,ISD and Local but it does not work when i apply CSS and Partition to my phones
4)Also Remote iste uses AREA CODE for dialing to other cities 0124
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...