Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Route pattern

Dear all,

I want to configure a route pattern to route call to the PSTN. To get the line on the PSTN network , i have to dial a security code number *54#1293*14#.

I configured my route pattern as :

- on the route pattern field : 1.[23789]XXXXXXX

- On the Discard digit field : Predot

- On the Prefix Digit (outgoing call): *54#1293*14#.

On my voice gateway , the dial-peer configured is :

dial-peer voice 70 pots

description LDHOTLINE

destination-pattern 1[23789].......

port 1/0/1

forward-digits 8

When i dial the number 1 96297967 from my IP phone , i have the message " Your call can not be computed" .

Thanks for your help.

3 REPLIES
Blue

Re: Route pattern

You've got a routePattern that strips the "1" from the dialed digits before sending the call to the gateway.

Then you have a gateway with an outbound dial-peer that is requiring a "1" as the leading digit.

Remove the discard digit predot and the dot and test again. (or use another prefix number w/a dot and strip predot)

Bottom line is that your dial-peer will not accept numbers that dont start with "1" in this case.

(you could use the 'prefix' command under your dial-peer)

(plus 8 digits forwarded to the PSTN doesn't look right...if your USA, it is 7 digits or 11 digits (unless 1 prefix not required for some LD calls)

New Member

Re: Route pattern

Hello gpulos.

I removed the discard digit predot and i configured the voice gateway as

dial-peer voice 70 pots

description LDHOTLINE

destination-pattern *54#1293*14#1[23789].......

port 1/0/1

Now , the call is forwarded to the PSTN.

But the PSTN send a voice message telling that i must dial the code number first.

Which command can i use to be sure that all the digit *54#1293*14# are forwarded to the PSTN ?

Thanks.

Cisco Employee

Re: Route pattern

configure forward-digits:

forward-digits

http://www.cisco.com/en/US/docs/ios/12_2/voice/command/reference/vrf_d.html#wp1127260

POTS dial-peers strip all exact matches by default unless configured otherwise

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
305
Views
0
Helpful
3
Replies