Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

session target ipv4 redundancy

Hi,

I`m going to make a voice network.

But I have a question to make a voice network.

I want to make a redundancy the session target ipv4 address.

Is it possible to make a redundancy session target address?

please let me know how to make a redundancy the voice network.

Thanks!

1 REPLY
Cisco Employee

Re: session target ipv4 redundancy

Hi,

You can use the command "preference" to specify backup destinations with dial peers. Example:

dial-peer voice 2000 voip

preference 1

destination-pattern 2000

session target ipv4:10.1.1.3

dial-peer voice 2001 voip

preference 2

destination-pattern 2000

session target ipv4:10.2.2.3

Lower preference is prefered. Have a look at the command reference for further details, f.e.:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_command_reference_chapter09186a00800b350f.html#wp999679

In general it might be useful to have a look at the Solution Reference Network Design guides for voice, which can be found at www.cisco.com/go/srnd

It contains design guides with best practice examples for various scenarios.

Hope this helps! Please use the rating system.

Regards, Martin

1174
Views
0
Helpful
1
Replies