I'm stuck trying to configure acd-aa script version 188.8.131.52 on a CME version 12.4(24)T, I follow the configuration guide of others routers on this forum but don't get what is missing. I don't have a hunt-group configured cause there is only one operator, the operator extension is 202, and this are the lines configured:
application service aa flash:app-b-acd-aa-184.108.40.206.tcl paramspace english index 1 param number-of-hunt-grps 1 param handoff-string aa param dial-by-extension-option 1 paramspace english language en param aa-pilot 220 paramspace english location flash: param second-greeting-time 30 param welcome-prompt _bacd_welcome.au param call-retry-timer 15 param max-time-call-retry 700 param service-name queue ! service queue flash:app-b-acd-220.127.116.11.tcl param aa-hunt 202 param queue-manager-debugs 1 param number-of-hunt-grps 1
! interface Loopback0 ip address 172.16.32.32 255.255.255.255
! dial-peer voice 220 voip service aa destination-pattern 220 session target ipv4:172.16.32.32 incoming called-number 220 dtmf-relay h245-alphanumeric codec g711ulaw no vad
When I dial pilot extension 220, I get an error tone, if you got this application running, please check for the lines above to check on what I'm wrong.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.