Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

setup CME to CUBE

Hello,

i want to setup a CME which has a SIP trunk to a CUBE.

Both are running in my test lab.

Can anyone help me with the configuration of both? Do i need to setup a User Agent on both or only on the CME?

Thanks in advance.

regards, Marty

Everyone's tags (3)
1 REPLY
Cisco Employee

Re: setup CME to CUBE

You'll just need to configure dial-peers to point calls between the two devices. There is no need to register anything.

On the CME it should look something like this,

Inbound dial-peer:

dial-peer voice 1 voip

incoming called-number

session protocol sipv2

dtmf-relay rtp-nte

codec g711ulaw

no vad

Outbound dial-peer:

dial-peer voice 2 voip

destination-pattern 9T

session protocol sipv2

session target ipv4:

dtmf-relay rtp-nte

codec g711ulaw

no vad

You'll need to configure a translation rule to strip off the 9 either on the CME or CUBE.

Similar dial-peers will need to be configured on the CUBE.

-Felipe

758
Views
0
Helpful
1
Replies