Hi guys, can any have a temple or sample configuration SIP, dial-peer, and VoIP on cisco 3640 running 2T1s ports connected to a PBX. I can not connect to the remote voice server via, even can not ping the IP address in the serial inface. Please I need your help, asap.
if you cannot ping the interface you might have a connectivity issue. Can you post your config (remove passwords and the like). In case you have no connectivity there is no point in configuring sip ;-)
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.