Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SIP Gateway Configuration

Hello All,

I have 1 SIP application which works on SIP and recieves and places call. I am using cisco 2811 router as gateway and has E1 pri connection for placing and receiving calls. My challenge is what are configuration commands do i need to configure cisco Gateway so that any call comes to e1 should redirected to that sip application.

how router recognize that application.

Thanks in advance.

1 REPLY
Hall of Fame Super Gold

Re: SIP Gateway Configuration

For basic use, only dial-peer configuration and few entries under serial interface. You may need some translation-profile and rule however.

If you never used cisco before, begin from there:

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080147524.shtml

485
Views
0
Helpful
1
Replies