I configured two CME with SIP. one of the CME is supposed to bypass the call to public network. when I dialed from first CME, then call is forwarded to sencond CME then call forwarded to my cell phone. my cell phone rings but there is no voice and it is dead. what part of configuration should I check for troubleshooting? I defined sip dial-peer in two CME and dial-peer in second CME for outbound calls. thanks for your suggestion.
Call Redirect Enhancements to Support IP-to-IP Calls through the IOS Voice Gateway. The Cisco IOS Voice Gateway has been enhanced to use call redirection if an incoming VoIP call matches an outbound VoIP dial peer. The gateway sends a 300 or 302 Redirect message to the call originator allowing the originator to reestablish the call.
Two new commands allow you to enable the redirect functionality, globally or on a specific inbound dial peer. For command-level information, see the appropriate command page.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.