In order to broadcast some video on different VLAN, I use the MVR protocol on switch 2950 and 3560. This solution works, but I have some problemes when the switch reboot or when I do some intervention on the port (unblock an err-disabled interface, make a "no shut" for example). In those case, I must reactivate the MVR. The multicast flow reaches the switch, but the users can't access to it. I must write this sequence in configuration mode :
When I write those instructions, everything works. This solution is OK if I have 1 switch, but not on an entire network. I don't understand why this protocol don't start correctly, like the others process.
To be more specific, the IOS version for the 2950 is IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA9.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...