I need some help with my SPA8000 8 analog lines, i configured the 8 lines and it worked fine (8 lines were registered) for a period but after that 2 lines only are registered and the other lines are empty in the status screen attached although they have the same configuration, i tried to contact the SIP provider and we tried to solve and finaly we noticed that the problme was from SPA8000 so i tried to Hardware reset but same probelm happens.
the SPA8000 status doesn't even showing that the lines are not register (its empty).
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.