Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Switch 3560 Voice Vlan

Hello

I have a small doubt regarding the Switch for Voip Configuration, I always setup the voice vlans and Switch 2960 and 2950, but now I'm working with 3560 series switch and I found for add port to the Voice Vlans all the ports has to be Switchport Mode Trunk and Switchport trunk encapsulation dot1q. Why on this particular switch this type of configuration is need it.

Thanks

5 REPLIES
New Member

Re: Switch 3560 Voice Vlan

What version of IOS? Sounds like it needs an upgraded version.

switchport access vlan xx

switchport voice vlan xx

New Member

Re: Switch 3560 Voice Vlan

The Switch has the latest IOS but the issue is why the ports has to be Mode trunk for the IP Phone Works?

New Member

Re: Switch 3560 Voice Vlan

Are they Cisco IP phones? I don't think the switchport voice/access commands work with third party phones.

Cisco Employee

Re: Switch 3560 Voice Vlan

For Cisco IP Phones, you will not need to use the 'switchport mode trunk' command.  You should be able to use the standard voice vlans.  If this is a thrid party phone, you may need to configure the switchport as a 802.1q trunk.

--Matt

New Member

Re: Switch 3560 Voice Vlan

Trunk mode issue is due to the fact that these ports accept tagged info from IP phones apart from untagged from PC, prior to this version we can configure it in access mode, to be very specific the same is in “a quasi access” state to engage both types of packets.

Encapsulation has to be specified because these switches support both ISL and IEEE standards, hence to avoid conflict explicit configuration commands as to be included between these standards 

Hope this will settle things...........

Thanks

656
Views
4
Helpful
5
Replies
CreatePlease login to create content