I have two 7206 with enhanced ATM cards attached to LS1010. I am setting up CBWFQ for my Tandberg VTC end point. In the lab environment, I used traffic generator to saturate the VC. For some reason, with or without QoS does not make any noticable difference on Tandberg performance (I try to break it).
Even with P2P T1 set up, the same result observed. Does anyone who uses Tandberg product notice the same thing? Even in production network, without QoS, Tandberg works great. But I want to know why. Thanks in advance
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...