Yes, I've used the multisite functionality (embedded MCU) in the Tandberg MXP 990 for multipoint conferences with VTA clients. In my scenario, the H.323 MXP 990 device (code revision F4.1) was registered to a gatekeeper, and the SCCP (VTA clients) simply dialled the E.164 number of the H.323 device. The MXP 990 spots another incoming call and creates a conference. I did find that the MCU functionality wouldn't work through an IP-IP Gateway, but I haven't tried this with a more recent 12.4T IPIPGW release. Also, I didn't try the MXP registered as a native H.323 device in CallManager.
In its role as an embedded MCU, the device will be generating multiple audio and video RTP streams with the conference participants, so you should be mindful of the bandwidth requirements and the placement of the endpoint within the network. (The placement of dedicated MCU resources may be different to an embedded MCU within an endpoint, which will more likely be sited towards the network edge).
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...