This will depend upon the resolution (720p or 1080p) being used. Generally, between 2 and 3 Mbps per screen is used. It is important to note that this bandwidth does not need to be dedicated bandwidth. Cisco specializes in managing dynamic, real-time applications such as voice and video that rely heavily on the quality and intelligence of the network, and run within the network, not on top of it. When Cisco TelePresence calls are not active, this bandwidth can be devoted to other enterprise applications. When Cisco TelePresence calls are made, quality of service and bandwidth reservation capabilities in the network allocate the bandwidth needed.
one the most important thing considering WAN is the interface speed, which according to the design guides should be greater than DS3
with a new codec software 1.5, the thresholds (loss and jitter) are not so restrictive, so it can keep working (previously the call was disconnected) with some level of loss and jitter which can be caused by slower interfaces
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...