Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Translation Help

I was able to get a translation to work on all inbound numbers, but I have a single fax on fxs0/1/0 that is getting lost in that translation.  Can someone assist in a translation that would see the fax number (555)555-1112 and point it off to the fxs?


Thanks


voice translation-rule 50
rule 1 /\(.*\)/ /317\1/    ------fax getting lumped in with this
!
voice translation-profile inbound
translate called 50
!

dial-peer voice 101 pots
destination-pattern .T
port 0/0/0:23
forward-digits all
!
dial-peer voice 115 pots
incoming called-number .
direct-inward-dial
port 0/0/0:23
!
dial-peer voice 112 pots
!
dial-peer voice 200 voip
translation-profile outgoing inbound
destination-pattern 555.......
session protocol sipv2
session target ipv4:10.173.0.2
dtmf-relay sip-notify
codec g711ulaw
no vad

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Translation Help

You don't need any translation. Just place the number as it comes from telco, as destination-pattern in the DP pots for the relevant port.

4 REPLIES
Hall of Fame Super Gold

Re: Translation Help

You don't need any translation. Just place the number as it comes from telco, as destination-pattern in the DP pots for the relevant port.

Re: Translation Help

Hello,

Coul you please let me know how many digits are you getting from the PSTN as DNIS to know how to manipulate them in the proper way. You could find that information in the output of the "debug voice ccapi inout"

<-------------------->

Walter   Solano

CCNA Voice

UCCX  Specialis

New Member

Re: Translation Help

Walter,

The telco was bringing in 7 digits and the SIP server required 10. That was the issue.

Re: Translation Help

Hello,

I tested the translation and its doing the translation in the proper way, but since the fax calls are coming into a different port we need either create another incoming dial-peer for that or apply the translation rule to the voice port itself.

You could find more information about how to map the translation rules to the dial-peer or voice ports:

http://www.cisco.com/en/US/partner/tech/tk652/tk90/technologies_configuration_example09186a00803f818a.shtml#con7

Please if you need futher help, collect the follow debugs to know exactly whats going on:

Debug voice ccapi

Debug voice trans

320
Views
0
Helpful
4
Replies