Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Translation Pattern " Inbound Digit Manipulation"

Hey Everybody ,

I would like know how to translate all incoming call on 842000 to 2987135. The setup as the following

1. I have Voice Gateway 2821 with E1 interface

2. 500 DID ( 2987000 to 2987499 ) are mapped on the E1 line from the exchange

3. The exchange pointing 842000 to first DID (2987000)then it will hunt 2987001 ---to-- 2987499.

what i would like to do , it to map all incoming calls on 842000 to ring on 2987135 instead of 2987000.

It would be appreciated to feed me back with the optimum solution.

Regards,

3 REPLIES
Hall of Fame Super Red

Re: Translation Pattern " Inbound Digit Manipulation"

Hi Mohammed,

I think that the optimum way to do this would be to ask your carrier/provider to re-map 8420000 to point towards 2987135. We do this type of change all the time. Make sure you indicate to them the number of simultaineous calls you wanted routed to 2987135 in this method.

Hope this helps!

Rob

Please remember to rate helpful posts.....

New Member

Re: Translation Pattern " Inbound Digit Manipulation"

Hello ,

The carrier will not do it for me as they have default setup . So How can i point all incoming traffinc from 842000 to 2987135 and leave 2987000 for operator only

Regards,

Re: Translation Pattern " Inbound Digit Manipulation"

If I understand you correctly here is my thoughts.

The when someone calls 842000 telco is remapping this to 2987000 and hunting across the other numbers. The problem is that the number getting passed to the circuit is 2987000 not 842000. With that said if you can't get the telco involved I don't think anything can be done. If you can then do this have them not do a roll on the number 842 and included that in your did block. That way you'll see 842000 come in on the circuit at that point you can add a translation partern in cm to send it where every it needs to go.

148
Views
0
Helpful
3
Replies