Technically, yes - all the ports can be enabled with all the features at the same time. However, it is best to designate (this is an average - actual port allocation should be based on busy data) about 75% of your ports to answer calls. Then leave the other 25% dedicated to MWI/notification and TRAP if you choose to use that feature.
Well, here is a basic answer to your question. If all your ports are busy on a regular basis then you need to add more ports. You can certainly enable all ports to perform all functions but that's not really addressing the root of your issue which is port capacity.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...