Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Urgent: sometimes CUBE does not send h225 messages

I've got a Cisco2821 used as CUBE connected via h323 to CallManager 4.2 and on the other hand connected via SIP to Microsoft Mediation Server.

When I call from OCS to a CiscoPhone, sometimes there is no voice and when there is voice, it is not possible to take the call on hold at the OCS Client, it just mutes the microphone.

When there is no voice, the call is disconnected after some seconds

When there is voice, there are SIP messages, but no h225 messages on the CUBE.

Attached you find a output of debug h225 q931 and a show call active media compact and the relevant configuration.

What I'm wondering, from where comes the g729r8 codec in the show call active media output, as there is nowhere g729 enabled.

1 REPLY

Re: Urgent: sometimes CUBE does not send h225 messages

Probably there is no incoming dial-peer configured. AFAIK when this happens, you call matches with 0 dial-peer which has g729 configured.

183
Views
0
Helpful
1
Replies
CreatePlease to create content