Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using fractional PRI, E1 for inbound and outbound calls

i need to use half of the channels for the inbound calls and half of the channels for outbound calls.

What would be the Configuration?

2 REPLIES
Hall of Fame Super Gold

Re: Using fractional PRI, E1 for inbound and outbound calls

Are you using CM, and if so with MGCP or H.323 ?

If H.323, place the isdn interface in trunk-group. Under said trunk group set the maximum number you want for incoming and outgoing.

interface serial x/y:15

trunkgroup mytrunk

trunk group mytrunk

max-calls voice 15 direction in

max-calls voice 15 direction out

dial-peer voice 100 pots

destination-pattern ...

trunk-group mytrunk

Hope this helps, please rate post if it does!

New Member

Re: Using fractional PRI, E1 for inbound and outbound calls

Thanks Paolo Bevilacqua! for replying but this solution is not working, I am using CCM 4.1, and MGCP on 3620.

Thanks

185
Views
4
Helpful
2
Replies
CreatePlease to create content