Using fractional PRI, E1 for inbound and outbound calls

[zubair]

i need to use half of the channels for the inbound calls and half of the channels for outbound calls.

What would be the Configuration?

[paolo bevilacqua]

Are you using CM, and if so with MGCP or H.323 ?

If H.323, place the isdn interface in trunk-group. Under said trunk group set the maximum number you want for incoming and outgoing.

interface serial x/y:15

trunkgroup mytrunk

trunk group mytrunk

max-calls voice 15 direction in

max-calls voice 15 direction out

dial-peer voice 100 pots

destination-pattern ...

trunk-group mytrunk

Hope this helps, please rate post if it does!

[zubair]

Thanks Paolo Bevilacqua! for replying but this solution is not working, I am using CCM 4.1, and MGCP on 3620.

Thanks