Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using Video Advantage reboots 2821 ISR!!

Hi everyone,

I have a site that suffers from intermittent router reboots when users within the site use the VTAdvantage cameras for video calls. By disabling all VTA's, everythings fine but even with one VTA connected this can cause the router to reboot. I've had all the hardware (inc DSP's etc) replaced, but this hasnt made any difference. The amount of bandwidth specified for video with CCM (ver 4.1.3) has been set to 2Mbps, each video session takes approx 256k - 312k. Theres nothing in the router logs to suggest any problems - maybe it reboots before it has time to write anything?

I have other sites with the same setup/config etc and these are all fine - it's just this one site.

Any suggestions appreciated!!

Thanks,

Mark.

4 REPLIES
Hall of Fame Super Gold

Re: Using Video Advantage reboots 2821 ISR!!

Which exact IOS are you using ?

New Member

Re: Using Video Advantage reboots 2821 ISR!!

Hi,

I'm running Version 12.4(15)T3, the problem is certinly related to the use of VTA, I have a POlycom VSX 7000 (via H323 gateway)into the WAN on site and have no issues whatsoever with that - if I make a video call from the site it will fail somewhere between three and ten minutes.

Re: Using Video Advantage reboots 2821 ISR!!

You may want to try 12.4(15)T10

New Member

Re: Using Video Advantage reboots 2821 ISR!!

Yes - upgrading the IOS was my next step - I'll give it a go and keep my fingers crossed!!

154
Views
0
Helpful
4
Replies