I have a Tandberg MXP3000 configured as an H.323 client in CallManager 4.0.2a, I am running into some issues when calling between Cisco VTA and Tandberg MXP3000.
When I initiate a call from the Tandberg MXP3000 to a Cisco VTA I can only see the extension number display but the Cisco VTA can see both the extension and the name display. And on incoming call initiated from the Cisco VTA, the Tandberg MXP3000 can only display the IP address of the CallManager where the calling phone is registered.
Can someone helps explain if this is a normal behavior between a SCCP and an H.323 client ?
And another issue is the Tandberg MXP3000 looses its remote video stream after it was put on hold and resume.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4