I am trying to come up with a design for our company video conferencing solution. Currently I have a Cisco CallManager infrastructure in place with about 20 Cisco VTA's and about 4 Tandberg MXP 3000 and all endpoints register directly to CCM with no MCU nor any of the components below. The Tandberg endpoints are currently register to CCM as H.323 client and I can dial by 4-digit extension between endpoints and I love that and I want to keep the 4-digit dialing as I expand. I will be adding the components below to allow outside access and multi-point conference calls. My ultimate goal is to preserve the 4-digit dialing between endpoints throughout the company while still be able to come up with a simple, user friendly dial plan for endpoints to dial out via ISDN or via IP.
Has anyone run into this type of scenario with similar components involve ?
-a 30-port Codian MCU
-Codian ISDN Gateway
-Codian IP Gateway
-Codian Gatekeeper - not sure if I need this component.
-Tandberg Edge 95 Endpoints - about 15 more.
-More Cisco VTA's
Thank you very much in advance !! I appreciate any comments/suggestions !!
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...