Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Video qos over mpls link

All,

I'm about to set up a video conference system between branches over our provider's mpls network. It would look like the following:

video equip (10.5.5.5) -> (fa0/1) branch (s0/0) -> provider -> (s0/0) corp (fa0/1) -> video equipment (10.7.7.7)

QoS has been applied at both ends (Branch/Corp) from the provider's viewpoint. I need to know how the best way to handle qos would be. Below is what I'm thinking:

Branch router:

access-list 20 permit host 10.5.5.5


class Inbound

match ip address 20

class outbound

match ip dscp af41

policy-map Inbound

set dscp af41

policy-map Outbound

bandwidth 512k

int fa0/1

service-policy input Inbound

int S0/0

service-policy output Outbound

This is all from my head above, so I figure the syntax isn't 100% correct. My goal is to ensure that the incoming traffic from the device is marked with AF41. On the Corp side, I would have another policy map INBOUND that states to match on the AF41 and then I'm assuming that I would set my bandwidth statements on Outbound on the Corp fa0/1 side? That's where I'm confused.

Thanks!

John

HTH, John *** Please rate all useful posts ***
403
Views
0
Helpful
0
Replies