We are in the middle of rolling out VCS-C/E, TMS and MCU and we are wondering if we might be able to get video between calls on our existing 7975 phones. I was under the impression that the Jabber client would be able to handle such interactions, but thus far I have not been able to make it work.
If I place a call from Jabber IM&P to Jabber IM&P I get video. If I use the 7975 on either or both ends I do not get video. Each 7975 does have a camera icon above the "More" button, which indicates that it sees the camera on the PC perhaps, but still nothing. Before I spend 4 hours trying to make it work, is it even possible to do this?
We are at 9.1 on both CUCM and Unified IM&P. We may upgrade to 10.x sometime next year after a few releases come out to fix majority of the bugs.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...