I am trying to do tdm switching on my as5400 to terminate voice trafic i would be receiving from my service provider but when i try to configure pot s i am unable to get voice port command (port 6/4:15).
Do you see a voice-port 6/4:15 in the global configuration or any voice-ports?
If you have no voice-ports then do you have any ds0-groups defined under controller interface? ds0-group will create a voice-port that can be applied to a dial-peer. Another reason voice-ports will not show up is if there are no DSPs.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...