Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Voice Vlan and Native Vlan

Dear all,

I am now reading some information regarding the setup of Voip Phone. It mentioned that the Phone is actually a 3-ports switch:

Port 1: Connect to upstream switch

Port 2: Transfer Phone traffic

Port 3: Connect to a PC

Actually, what should i configure on the upstream switch port? Should it be a trunk port containing both the voice traffic vlan and pc data vlan?

Or something else?

Also, there is a term called 'Voice Vlan', is there any different between 'Voice vlan' and ordinary Vlan ?

Is there any special usage of 'Native' Vlan in implementing Voip?

Thanks.

Br,

aslnet

4 REPLIES
Hall of Fame Super Gold

Re: Voice Vlan and Native Vlan

The switch port is configured for access but also specifying what the voice vlan is.

The voice vlan is like any other vlan except that cdp carries this information so the phone knows what vlan to use for voice.

Native simply means untagged vlan.

New Member

Re: Voice Vlan and Native Vlan

Thanks. That means the access port would configured as 'voice' vlan access port. Then CDP told the IP-Phone what is the voice traffic vlan.

AFter the Voip phone get the CDP and then tagged the Voice traffic as voice vlan in its internal switch, right?

While for the data port, it would then travel as native vlan (no tag), when the switch receive this native traffic, it would pass it as native also, right?

In general, native vlan is vlan1, that means the data traffic general must be in vlan1?

Hall of Fame Super Gold

Re: Voice Vlan and Native Vlan

Yes, exactly.

Hope this helps, please rate post if it does!

New Member

Re: Voice Vlan and Native Vlan

Thanks.

How about if the PC data should be tagged as another vlan (e.g., Vlan 10)? Then I should change the native vlan to vlan 10?

But from my understanding, Native Vlan should be the same in the whole network, then I need to change the whole network native vlan? If there are different vlans should be assigned to different PCs that behind different VoIP-phone, then how to do it?

From my guessing, is it i can assign individual native vlan (vlan10) on that port (connect to voip-phone), and then keep the switch's uplink port as original native vlan (vlan1).

Therefore, PC data traffic would be untagged when entering from voip to the switch, and then tagged as vlan10 when leaving the switch to other uplink switch, right?

Thanks.

314
Views
0
Helpful
4
Replies
CreatePlease login to create content