we have SIP service provider for our CME. some incoming calls to CME are one way audio but some work fine. I did "show voip rtp connection", and in the one way audio call, I saw CME chose the loopback interface as source RTP stream, which has private IP address and it's not routeable over the internet, that's why it's one way audio. In the good calls, CME chose the gi 0/0 interface which has public IP address and there is two way audio. How can I force CME to use only Gi 0/0 as the source RTP stream?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...