I am looking to implement VOIP for 7 users and the routing/QOS will be controlled by 2 * 2901's.
I have very little knowledge of QOS on Cisco apart from auto qos voip ;-)
My main concern is I need to QOS the traffic on our WAN interface 20Mb BUT the VOIP traffic will be going over a GRE/IPSec tunnel over the WAN interface.
I presume that on the WAN interface it will just see IPSec packets and not understand they are VOIP to gain greater priority? On the tunnel it will understand VOIP and non VOIP traffic but if someone is hammering the WAN link VOIP packets inside IPSec packets will get dropped?
Please could someone help me understand if this is correct and or the best methods to attackt this setup.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...