voip vs. pots dial peer on redundant H.323 gateways
I have 2 H.323 gateways which I would like to use in a redundant fashion.
I configured 3 dial peers on GW1: PRI first, then voip dial-peer to the 2nd GW, then POTS line for backup (config is in the attachment). However, it looks like the pots dial-peer for backup POTS line is always used before voip dial peer even though its preference number is higher.
Is it a feature of pots dial-peers that they are preferred over voip dial peers if destination-pattern is the same? I can't find a confirmation on CCO.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.