Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1750v & AS5350 VoIP config sample

Im trying to set up a demo VoIP network between my offices in 2 location using an AS5350 (FXS) at the central site and 1750V (FXS) at a branch for now. They will both be linked by VSAT(fastEthernet output). Basically i just want to be able to make calls accross. Can someone help me with a sample config to lead me.

  • Voice over IP
1 REPLY
Silver

Re: 1750v & AS5350 VoIP config sample

If you are using the 5350, that has no analog ports, i am assuming you are using a T1 and doing fxo on the individual t1 channels.

You will need to set up your controller as :

controller t1 1/0

framing esf

linecode b8zs

ds0-group 0 timeslots 1-24 type fxo-ground-start

which will create a voice port :

voice-port 1/0:0

then you will need two dail peers each on the routers :

one to send the voip call to the other side

dial-peer voice 1 voip

destination pattern 1234 <--- number of remote side

session target ipv4:10.1.1.1 <--- ip address of remote side

and one to terminate the call on this router

dial-peer voice 2 pots

destination-pattern 5678 <--- local number

port 1/0:0 <--- local port

no digit-strip

On the analog side you will have two ports already associated and you should congiure them under the appropriate dial peers.

You can also take a look at :

http://www.cisco.com/warp/customer/788/voip/dialpeer_call_leg.html

http://www.cisco.com/warp/customer/788/voip/in_dial_peer_match.html

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080aec.html

Regards,

Taimoor

264
Views
0
Helpful
1
Replies
This widget could not be displayed.