Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1751-V & ATA-186 Incompatibility

Hi There,

I have a VoIP network, of two Cisco 1750-4V, two Cisco 1751-V multiservice routers and two ATA-186 voice gateways.

The communication between any 1750-4V and ATA-186 devices is flawless in both directions. However, when we try to make a call from 1751-V (FXO or FXS port) to the ATA-186, it's impossible. The communication from any ATA-186 to any 1750-4V, the other ATA-186, and any 1751-V (FXO or FXS port) is flawless.

I don't know if a newer version of ATA-186 flash ROM (actually there is 2.07 version) will solve this problem?

I will appreciate any comments.

Regards,

Igor Sotelo.

2 REPLIES
Silver

Re: 1751-V & ATA-186 Incompatibility

I have a setup in which ATA-186 and 1751-V are interopearting without any issues. My setup is similar to the one in the document http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a0080094669.shtml.

New Member

Re: 1751-V & ATA-186 Incompatibility

Thank you for the information.

We don't use a gatekeeper, and I have the following configuration on both 1751-V (the configuration is the same on the 1750-4V's):

dial-peer voice 5000 voip

.destination-pattern 500.

.session target ipv4:x.y.z.w

where x.y.z.w is a external valid IP address.

On the ATA-186 we have configured:

static IP: x.y.z.w

static net mask: 255.255.255.240

UID0: 5000

UID1: 5001

and static route: x.y.z.w1

I can ping the devices from the 1751-V without problems, and also call the 1751-V from the ATA. However, I can't call the ATA from the 1751-V.

Do you have idea, of what can be wrong?

Regards,

Igor Sotelo.

238
Views
3
Helpful
2
Replies
CreatePlease to create content