My company plan to use VoIP to interconnect the remote-site. The traffic will not be very high. I am thinking about to use 4 FXO ports or use E1 to connect to my PBX. I am afraid that if I use E1, the PBX is not compatable with the 2600 router. I am not an expert of PBX. I hear that PBX often use their private protocol and their is many problem in inter-operate with different PBX. So I am afraid that. Although use 4 FXO ports is enough in normal case. But I think more channels is better. So Can anybody give me some idea? Thank You!
You need to use the PBX which supports E1 or T1 line. Rest is all based on the signalling between PBX and 2600. Many PBX now a days supports all ffavoures of T1 and E1 signalling. Also 2600 supports that so i don't think it should be a issue.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...