I need a sample config for a 2650XM with FXO ports that will be used to route incoming calls to a particular group and that same group will be making calls out that same gateway. I am on CCM 3.3(3)sr3.
If anyone can help me or point me to documentation that would help I would greatly appreciate it.
For a basic H323 gateway, the following would work :
interface ethernet 0/0
ip address 22.214.171.124 255.255.255.0
h323-gateway voip bind srcaddr 126.96.36.199
description - fxo to Call manager
connection plar opx 1000
dial-peer voice 1 voip
description - VOIP calls to call manager
session target ipv4:188.8.131.52
ip precedence 5
dial-peer 10 pots
Create a H323 gateway in the CM config and give it the name of the router's ethernet IP address.
Create a route pattern of 0.XXXXXXXX where the XXXX's represent the digit string to send out to the PSTN , so each X represents a unique digit.
Point the route pattern to the H323 gateway , and under called party transforms set the discard digits to none, so the called number that hits the gateway router is prepended with a 0. This 0 will be stripped off by the router POTS dial peer, but it will leave the rest of the string intact.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...