02-14-2004 05:48 PM
All
When my mobile phone switched off, we will recieve a message saying that my phone is out of reach or power off.
But I use 3620 + ISDN T1 call to my off mobile, I still recieve a ringtone from VOIP (fxs)?
Why my ISDN or VOIP not receiving the same "power off" message?
02-19-2004 12:13 PM
If the terminating switch would like to play a tone/announcement it should send progress with pi =8.
02-19-2004 06:53 PM
Thx sbilgi for reply.
Really thx
I had tried...
dial-peer voice xxxx pots
destination-pattern xxxxT
progress_ind progress enable 8
direct-inward-dial
port 1/1:23
but still not ok....
Later I had also insert
voice call convert-discpi-to-prog (global configuration)
still not ok....
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a0080111b58.shtml#busytone
3620gw#sh version
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3620-J1S3-M), Version 12.2(15)T10, RELEASE SOFTWARE (fc2)
I had checked with my ISDN line provider, they said their line should be ok.
02-23-2004 05:42 PM
Thx for Sbilgi direction.
My problem is I had generated local ringback tone on FXS.
Now the problem is solved.
Thx sbilgi
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: