Hi I have a cisco 3725 with two PRI being backhauled to callmanager. I also have an NM_HDA with 8 FXO ports on the same router. In callmanager all voice ports are registered and the two PRI's work fine for inbound and outbound calling. My problem is the FXO ports, I can call in and they will ring the phone for the extension that they are configured for, but when I make a call out using the FXO ports, I get a busy signal.
If I am backhauling the PRI's do I need to configure a Dial-Peer for them or not because I think that may be my problem for outbound calls for the FXO ports.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...