The drop threshold should be lower than the shutdown threshold (if configured) and should be based on the maximum
amount of PDUs you expect to receive on a port and on the CPU utilization during peaks hours. These values usually determine what is a normal peak condition and therefore what could be an abnormal peak condition. Then you can set the threshold between the two to avoid excessive spikes of PDUs on a port
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...