Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

5300. Using VoIP, and dialup at the time.

How to configure 5300 to works with dialup and voice traffic simultaneously ?

Now I can dial in to 5300.

But when I tried to set VoIP session I get message "Destination out of order" (see debug isdn Q931 command below).

Where is a problem ?

On the other side is CallManager 3.3(2)c.

5300 has a IOS 12.2.15.T8 Enterprise Plus.

Earlier I used 3810 only as a H.323 gateway - it works fine.

Regards.

-- snip --

06:01:46: ISDN Se0:15 Q931: TX -> CALL_PROC pd = 8 callref = 0xDD00

Channel ID i = 0xA9839F

Exclusive, Channel 31

06:01:46: ISDN Se0:15 Q931: TX -> DISCONNECT pd = 8 callref = 0xDD00

Cause i = 0x829B - Destination out of order

06:01:46: ISDN Se0:15 Q931: RX <- RELEASE pd = 8 callref = 0x5D00

06:01:46: ISDN Se0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0xDD00

-- snip --

2 REPLIES
New Member

Re: 5300. Using VoIP, and dialup at the time.

do you have this http://www.cisco.com/en/US/partner/products/hw/univgate/ps501/products_installation_guide_chapter09186a008007c702.html#xtocid2629912 card installed?

if so, please, show run int SerX/0:15 and dial-peers configs.

New Member

Re: 5300. Using VoIP, and dialup at the time.

Yes.

I have Quad E1 card, Voice DSP card (AS53-VOXD), and Digital modem card.

-- snip Serial config --

interface Serial0:15

no ip address

encapsulation ppp

autodetect encapsulation ppp

isdn switch-type primary-net5

isdn protocol-emulate network

isdn incoming-voice modem

no isdn outgoing display-ie

-- snip Serial config --

-- snip config for modem connection --

!

modem-pool access

pool-range 1-30

called-number 3940 max-conn 10

!

interface Group-Async1

ip unnumbered FastEthernet0

encapsulation ppp

async mode interactive

peer default ip address pool dialup

no keepalive

group-range 1 30

!

dial-peer voice 3940 pots

application data_dialpeer

incoming called-number 3940

-- snip config for modem connection --

-- snip dial-peer for voice --

dial-peer voice 1000 voip

destination-pattern 10..

session target ipv4:10.206.1.249

-- snip dial-peer for voice --

193
Views
0
Helpful
2
Replies
CreatePlease to create content