AAL2 Bles loosing conectivity after a few Idle minutes
i have set up an IAD2400 to use VoATM as outlined in the book:"VOAAL2 Profile 9 configuration" and the lines do come up and work as advertised, however; after a few minutes of being idle, we loose connectiviry and the only way of getting it back is to reset the voice ports. The CO voice gateway specifies the following: aal2 Bles mode, Cas-gr303 signaling,CAS refresh every 5 seconds, Idle CAS refreshing enabled and Combined use timer of 20 ms.
I have looked but so far I can't find the setting fo enable the idle cas refresh rate that i suspect is the problem.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...