Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ANy MIB to poll for no. of active voice channel on 2611 with T1 Module

Hi ppl,

I have a 2611 router with a T1 voice card (NM-HDV-1T1-24) as a voice gateway in my office. IOS version c2600-is-mz.122-11.T2.bin has been loaded and running.

I have tried to poll the mib oject "cvActiveCallConnectionID " under the Cisco-Voice-Dial-Control MIB for no. of active voice channel. I use solarwinds engineering edition 2002 to poll this device. It shows an error said that the mib is not supported in this version of IOS. We are running VoFR in our existing environment

I have checked in the Cisco MIB webpage --

ftp://ftp.cisco.com/pub/mibs/supportlists/c2611/c2611-supportlist.html

-- that the IOS is supported in version 11.3!!! Is it only support in 11.3 or any later version?

If not, any possible mib or workaround can solve my problem.

Regards,

Sam

1 REPLY
New Member

Re: ANy MIB to poll for no. of active voice channel on 2611 with

The information is in the mib object cvCallActiveTable. There is no frame-relay equivalent to the VoIP object. The only frame-relay specific SNMP info you can verify is CISCO-VOICE-FR-DIAL-CONTROL-MIB

462
Views
0
Helpful
1
Replies