Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AS5300 and CLID problem

Dear all,

I would like to get help from all the professional here.

I have a cisco as5300 gateway, receiving calls from the as5400 in voip. The calls will be routed to the T1 ISDN interface of my as5300. I want to force the CLID to be sent to the T1 ISDN as a predefined value (let say ... 34567890).

Is it possible to do so ?? Thanks in advance !

Here is my dial-peer configurations:

dial-peer voice 2888 voip

incoming called-number 2888.T

answer-address 34567890

session target ipv4:2xx.xxx.xxx.xxx

dtmf-relay cisco-rtp h245-signal h245-alphanumeric

codec g723r63

dial-peer voice 13 pots

answer-address 34567890

destination-pattern 2888T

progress_ind setup enable 3

progress_ind alert enable 8

translate-outgoing called 2

direct-inward-dial

port 3:D

1 REPLY
New Member

Re: AS5300 and CLID problem

use isdn calling-number

on the main isdn interface (ser3:15)

regards,

Andreas

144
Views
0
Helpful
1
Replies
CreatePlease to create content