To gracefully disable a modem from dialing or answering calls, use the modem busyout command in line configuration mode.
The disabling action is not executed until the active modem returns to an idle state. No active connections are interrupted when you enter this command. If the modem busyout-threshold command is set, this command will be delayed until the DS0 lines to the exchange are taken out of service. For T3 cards the message "No Controller configured" might appear for unconfigured T1 links in the T3.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...