I configured an AS5400 with 12 E1 PRI ports as Network Side, but i want to select which ports will send clock and others will be silent, because opposite side PBX is waiting clock only from one E1 , And it doesnt allow me to enter line clock source under controller . I tried to enter tdm clock command but it doesnt solve slip error problem, both side take slip errors except first line, that opposite side expect clock. CRC and switchtype is same for all lines, can you help me ?
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...