Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AS5400 (with np60) and VoIP

Do I need an special configuration to use np60 module to an E1 for VOIP?

  • Voice over IP
1 REPLY
Bronze

Re: AS5400 (with np60) and VoIP

You acn refer the following document for the configuration. No special configuration is needed for NP 60 module

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/as5350/sw_conf/53swcg

169
Views
0
Helpful
1
Replies
This widget could not be displayed.