I have an AS5400XM in which different providers terminate traffic to it form remote locations and I send this traffic over ISDN E1s to my PSTN switch.
Now my problem is that I need to map each dial peer on the VOIP coming from the remote site to a specific ISDN E1 (POTS) or group of E1s that go from the AS5400XM to the PSTN.
In other words I want to separate the different terminating sites to have their own E1/s going into the PSTN so I can Bill the remote sites from the PSTN based on the trunk group/s going to the PSTN from the AS5400XM
Can anybody out their help me with the configuration on the AS5400XM
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...