Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA- Getting "TCP connect err: -33"

In my setup, from G/w I am able to ping the ATA, but I am not able to make any outbound calls from the Analog phones ( not tried the inbound yet).

I ran prsrv.exe and found the following error

Connect to <0xdce08005 1720>..

12:00;0,0,0,0,

12:30;0,0,0,0,

TCP connect err: -33

SCC:ev=7[0:0] 3 0

[0]StartTone 2

According to the document on cisco site

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a0080094adf.shtml

it is a IP connectivity issue. But from G/w I am able to ping the ATA.

Can you suggest what problem it could be?

Regards..

2 REPLIES
Bronze

Re: ATA- Getting "TCP connect err: -33"

since you can ping from the gateway its not a connectvity issue with the router, may be your router is not properly configured to route the call out , check for the router configuration.

New Member

Re: ATA- Getting "TCP connect err: -33"

Thanks for the reply. It was IP address confict, which was creating the problem.

262
Views
0
Helpful
2
Replies