Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ATA188 & anolog modem traffic

Has anyone succesfully passed analog modem traffic through the ATA188 analog phone adapter in a IP Telephony setup?

3 REPLIES
Silver

Re: ATA188 & anolog modem traffic

The data sheets don't seem to contain the information.

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_data_sheet09186a00800c4139.html

AFAIK, connecting a modem to the ATA is an unsupported hardware configuration.

Cisco Employee

Re: ATA188 & anolog modem traffic

Just to add to the previous person's post, The official response is that Modem passthrough/relay is NOT supported.

Do a search for mode in this FAQ

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_qanda_item09186a00800946e1.shtml

Some people have tried and had some limited success, but this has not been tested, and is not a supported use of the ATA.

Ademola

New Member

Re: ATA188 & anolog modem traffic

What has been your experiance with this, as I have the same question. I am about to start testing.

Also where is the phone type template for the ATA188?

I am running 4.0 and can't find the 188template

130
Views
0
Helpful
3
Replies
CreatePlease to create content